Sphere preview in Clip by sphere filter depends on coordinates of center if radius < 1
This issue was created automatically from an original Mantis Issue. Further discussion may take place here.
Load bluntfin.vts Set View direction to +X Apply Clip filter, Clip type Sphere Reduce Opacity to < 1 Check "Inside Out" and "Show Sphere" Set Radius < 1, e.g. 0.5
z-coordinate of center is by default 2.86212563514709 change it to 2.2 and then to 4 and compare size of preview sphere. Leave z-coodinate at 4 and change x- or y-coordinate, preview sphere will change its size again (not the clipped dataset, though)
Issue is not related to whether or not parallel projection is used.
Tested with PV 3.6.1 (Linux 32-bit) and CVS HEAD (Linux 32-bit)