When creating two Box sources, with the Boxes not centered on the origin, selecting the Outline representation is incorrect.
Steps to reproduce:
- Select Box from the sources menu
- For illustration purposes change the Y and Z Length to 100000, X Length to 0; center to 0,0,10000
- Apply
- Representation to outline
- Select Box from the sources menu
- For illustration purposes change the Y and Z Length to 100000, X Length to 0; center to 0,0,10000
- Apply
This appears to work correctly on either builtin or when connected to the server of your choice. I think it is working correctly when builtin is being used, because the dementions of both boxes are the same, but I could be incorrect. This only happens when there is an offset to the center of the box.
I also noticed that when connected to a server and outline is selected as the representation for Box1, the bottom of the box gets elongated. This may be the expected behavior, because the center is off, but then the builtin would be incorrect, because it dose not elongate the outline under the same circumstances.
Thanks,
-Phil
Edited by Mathieu Westphal (Kitware)