Display panel settings aren't used when a filter is created.
This issue was created automatically from an original Mantis Issue. Further discussion may take place here.
This is a problem for particle physics folks, and is really confusing - so I am marking it as urgent.
- ParaView 3.6.0. Local server. XP.
- Open can.exo. Apply.
- On the display tab, change Translate X to 10. Click in the window, make the can move.
- Filter/ Alphabetical/ Extract Block. Choose Unnamed block ID: 1. Apply.
Bug - notice that the can segment has not offset like the original.
- Go to the Display tab, and notice that the Translate X is correctly 10. This did not take effect.
- Click on Selectable, and the can will jump to the correct position.
- This also happens with point size. if you set it to 1, then make a new filter, point size won't take effect until you click something. It should automagically happen.