Selection inspector breaks easily
This issue was created automatically from an original Mantis Issue. Further discussion may take place here.
This happens on the trunk, XP. Open can.exo. Display/ Representation/ Surface with edges. Select Points On icon. Rubber band select a point. View/ Selection Inspector. At the bottom, Display Style, Point Label, select Visible. Select Points On icon. Rubber band select an area on the can, but NOT containing a point. an output dialog comes up that cannot be closed. It says "vtkLabeledDataMapper () Could not find label array (vtkOriginalPointIds) in input".
This window should either grumble once or not at all.
I did find a workaround - you just ignore the window, and select again. But it is confusing.