Funny error when changing histogram scalar
This issue was created automatically from an original Mantis Issue. Further discussion may take place here.
You can sometimes get a funny error when changing the histogram scalar when the view showing the histogram is not active. To see the problem, do the following.
- Load disk_out_ref.ex2 with all of the variables turned on.
- Add the histogram filter using Temp as the scalars. A new view containing the resulting bar chart is created just fine.
- Select the 3D view to make it active again.
- Change the Scalars in the histogram filter from Temp to Pres. After you Apply, you get the error message "Failed to locate the data to plot on either axes," and the bar chart goes blank. You can get the bar chart back by clicking on the bar chart view again.