Odd warning when applying interactive selection after query
This issue was created automatically from an original Mantis Issue. Further discussion may take place here.
If you try to apply an interactive selection after a query, you get an incomprehensible error box followed by the selection being cleared out. To replicate, do the following:
- Open can.ex2. Load all variables. Apply.
- Go to last time step.
- Open Find Data dialog.
- Make a cell query where EQPS >= 1.5.
- Close the Find Data dialog.
- Turn on interactive cell select.
- Select a cell.
At this point you get the output message "Failed to locate property: ContainingCells" (which is meaningless to users). The cell still gets selected, but the previous selection goes away.