Check/uncheck selected blocks fails in parallel
This issue was created automatically from an original Mantis Issue. Further discussion may take place here.
- Linux, master, remote server (8 processes, I bet 2 processes shows the bug).
- Open bake.e. (Ask Utkarsh for this, you you don't have it.) All vars on, apply.
- +Z Now, the left and right panel and center rail are visible. These are blocks numbers 123, 124 and 3.
- Select blocks. Rubber band select across the three blocks, say an area the size of an apple (few inches high, few inches wide). These three blocks are now selected.
- Properties tab, Check Selected Blocks.
<> We get the following warning messages.
Failed to locate block's name for block id: 4
Failed to locate block's name for block id: 4
Failed to locate block's name for block id: 4
Failed to locate block's name for block id: 4
Failed to locate block's name for block id: 4
Failed to locate block's name for block id: 4
Failed to locate block's name for block id: 4
Failed to locate block's name for block id: 118
Failed to locate block's name for block id: 118
Failed to locate block's name for block id: 118
Failed to locate block's name for block id: 118
Failed to locate block's name for block id: 118
Failed to locate block's name for block id: 118
Failed to locate block's name for block id: 118
Failed to locate block's name for block id: 119
Failed to locate block's name for block id: 119
Failed to locate block's name for block id: 119
Failed to locate block's name for block id: 119
Failed to locate block's name for block id: 119
Failed to locate block's name for block id: 119
Failed to locate block's name for block id: 119
Failed to locate block's name for block id: 119
<> Notice that only blocks 3 and 123 are still selected. 124 isn't selected. If you hit apply, you will also notice that 124 isn't selected. This is a bug.