Settings/ Geometry Mapper Options don't work
This issue was created automatically from an original Mantis Issue. Further discussion may take place here.
I think that the Geometry Mapper Options don't work, and/or are not even connected. Replicate as follows:
- Master, Linux, local server.
- Sources/ Sphere. Theta and Phi Resolution to 80. Apply.
- Surface with Edges. <> There will be some lines that seem to dip below the surface. These occur on my monitor about 7:30, about half way from the center to the edge.
- Edit/ Settings/ Advanced/ Render View. Change the z-shift range to a larger number (for instance, 1), Apply or OK. Sphere issues stay around. Close ParaView, restart. Sphere line issues stay around.
- Edit/ Settings/ Advanced/ Render View. Change the z-shift range to a negative number (for instance, -1), Apply or OK. Sphere issues stay around. Close ParaView, restart. Sphere line issues stay around.
I assume this means that the z-offset isn't working?
I also tried Polygon Offset (Offset Lines and Points relative to Faces), and that didn't seem to do anything either.