Contours, color by is crazy broken
This issue was created automatically from an original Mantis Issue. Further discussion may take place here.
When you contour, then color by something, ParaView gets very confused. I don't know if this is one bug, or numerous. Should be fixed for 4.2.
- Linux, local server, master.
- Source/ Wavelet. Apply.
- Slice. Turn off Show Plane. Apply.
- +X
- Hide visibility of Wavelet.
- Not necessary, but Reset (X)
- Contour, by rtdata, take default, apply.
<<Bug - you can't color by rtdata>> (Ah, this is by design, you say!)
- Restart ParaView from scratch.
- Open disk_out_ref.exo. All vars on. Apply.
- Slice. Turn off Show Plane. Apply.
- +X
- Not necessary, but Reset (X)
- Color by temp.
- Contour filter. Contour by temp. Change value range to 400. Apply. <> We are now contouring by temp. <> If you look at the Color By in the Properties tab, it doesn't show Solid Color (but should). The Color By in the top tool bar does!
- Color by "Solid Color". (Top tool bar.) (Contour goes white.)
- Color editor. Change color to black.
- Color by temp.
<> Contour stays black! You can never color by any var again, until you change the color back to white.