data arrys are changing when using the clip options
This issue was created automatically from an original Mantis Issue. Further discussion may take place here.
Paraview version 3.98 (also in 3.14)
When I make at clip in (borehole_round.vtk) the surface values that are potted change. I am 100% sure that I am using the same colorscale. Note that the data range for the data arrays in the clipped layer goes from -3.03585e-38 to 1.21784e+33 while the data range is normal (and correct) in the non clipped layer.
Best regards Nikolaj